Stadler Form EVA Gebrauchsanweisung Seite 20

a new cotton pad (commercially available) and add drops of the desired
fragrance.
12. If the water level indicator (16) changes to red, the water must be re-
filled. Remove the water tank (6) and fill it with clean, cold tap water
up to the maximum mark. After replacing the water tank, the appliance
automatically resumes operation after a few seconds. The water tank
can also be refilled during operation.
13. If you find the lamps too bright (in a bedroom, for example), you may
reduce the light intensity by pressing the night mode key (21):
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into nor-
mal mode.
If there is no water in the appliance, the red water level symbol (16)
lights up in all modes. The red light cannot be dimmed.
14. If two dots are shown (22) on the display (15), Eva cannot establish a
radio connection to the Remote Sensor
to a humidity sensor within the appliance. Press any button on the Re-
mote Sensor
(2) is within a 10 m radius of Eva. Walls, doors and floors between Eva
and the Remote Sensor
mote Sensor
3 – 5 m from Eva and on an elevated surface in the middle of the room
(see «Setup/operation» No. 3). The two dots on the display (22) could
also indicate that the batteries in the Remote Sensor
ing (see «Setup/operation» No. 2).
Note: Should you see droplets (or other signs of dampness) on or around
the unit, this condensed water is from the humidifier. This means that the
air can no longer absorb the moisture from the humidifier. Please activate
the auto mode with a desired humidity of 45 %. Water droplets should then
stop forming.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (1) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
If pre-heating is turned on (the warm mode LED is on (13)), the water inside
the appliance is heated: the water in the water tray (9) and the heating plate
(17) become hot. Avoid touching the water and the heating plate!
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Run the cleaning mode at least once per month. The appliance must
be off for at least 15 minutes prior to internal cleaning! Then remove the
water tank (6), the mist chamber (23), the silicone cover (18), the Silver
Cube (24) and the fragrance container (20). Fill a cup with 200 ml of tap
water mixed with descaling agent (mix according to the manufacturer's
instructions). Pour the liquid carefully into the water tray (9) by holding
the cup directly over the water tray (see page 5). Do not pour the liquid
into the water tray from high above the tray! Be sure that no liquid enters
the air inlet opening (26). This will damage the appliance and will void any
claim to the warranty.
(2) to activate it. Make sure that the Remote Sensor
TM
(2) can disrupt the radio connection. The Re-
TM
(2) should be optimally positioned at a distance between
TM
(2). Eva still functions thanks
TM
TM
TM
(2) need replac-