Ec Declaration Of Conformity; Cleaning And Maintenance - Bresser 5-in-1 Comfort Bedienungsanleitung

31 EC Declaration of Conformity

Hereby, Bresser GmbH declares that the equipment type with part number: 7002550000000 is in
compliance with Directive: 2014/30/EU.The full text of the EU declaration of conformity is available at
the following internet address: http://www.bresser.de

32 Cleaning and maintenance

• Before cleaning the device, disconnect it from the power supply (remove plug or remove batteries)!
• Only clean the device externally using a dry cloth. Do not use cleaning solution to prevent damage
to the electronic parts.
Cleaning the rain collector (sinkhole)
1. Rotate the rain collector by 30° anticlockwise.
2. Gently remove the rain collector
3. Clean and remove any debris or insects.
4. Install all parts when they are fully clean and dried.
Cleaning the thermo/hygro sensor
1. Unscrew the 2 screws at the bottom of the radiation shield.
2. Gently pull out the shield.
3. Remove carefully any dirt or insects inside the sensor casing.
Note
The radiation shield comprises different parts inserted one inside another. Two bottom parts are
closed. Do not change their order! Do not let the sensors inside get wet!
• Clean the shield with water and remove any dirt or insects.
• Install all the parts back when they are fully clean and dried.
Cleaning the UV sensor and calibration
1. For the most accurate readings, please use pure water to clean the UV sensor cover lens before
mounting, and then periodically.
2. You can also calibrate the UV index with some instrument grade UV meter to maintain a high ac-
curacy of the UV index reading.
39 / 44