Comfort Indication (Indoor); Data Clearing; Pointing The Sensor To The South - Bresser 5-in-1 Comfort Bedienungsanleitung

17 Comfort indication (indoor)

1
1 too cold
3 too warm
The comfort indication is a pictorial indication based on indoor air temperature and humidity in an at-
tempt to determine comfort level.
Note:
• Comfort indication can vary under the same temperature, depending on the humidity.
• There is no comfort indication when temperature is below 0° C (32° F) or over 60° C (140° F)

18 Data clearing

During installation of the outdoor sensor, the sensor could have been triggered, resulting in erroneous
rainfall and wind measurements. After the installation user may clear all the erroneous data from the
main unit without a need to reset the clock and re-establish pairing. Simply press and hold the HIS-
TORY button for 10 seconds. This will clear out any data recorded before.

19 Pointing the sensor to the south

The sensor is calibrated to be pointing to North by default. However, in some cases, users may wish
to install the product with the arrow pointing towards the South, especially for people living in the
Southern hemisphere (e.g. Australia, New Zealand).
1
1 Northern hemisphere
1. First install the outdoor sensor with its arrow pointing to the south. Please refer to "Installation"
chapter for mounting details.
2. Press and hold the WIND button for approx. 8 seconds until the upper part (northern hemisphere)
of the compass rose is blinking.
3. Press the UP or DOWN button to change to lower part (southern hemisphere).
2
2 comfortable
2
2 Southern hemisphere
3
33 / 44