Rhodius RH403S Originalbetriebsanleitung Seite 25

RH403S Original user manual
Assembly instructions:
Whatever your working groove width, always install ALL of the spacer discs.
At least 1 spacer disc must be installed between two diamond cutting discs.
When fitting the diamond cutting discs, make sure that the directional arrows on the
diamond cutting discs match up with the electrical tool's direction of rotation (see
directional arrow on the machine guard).
Always replace diamond cutting discs in pairs.
Always use original accessories.
The wall chaser's performance and rpm have been carefully matched to the RHODIUS
LD402 and LD403 diamond cutting discs.
Taking into account the materials to be processed (see overview: accessories), you will
achieve the best work results.
Always check the spindle lock is released before switching the machine on – you can do
this by slightly rotating the working spindle.
Let the machine idle briefly in a safe position. If the tool does not run smoothly, stop
work immediately.
Structural safety advice
national regulations.
Compliance with this standard is required at all times.
site management.
thickness and the wall material.
GB
25