Rhodius RH403S Originalbetriebsanleitung Seite 19

RH403S Original user manual
Scope of delivery
Intended use
when fully assembled.
discs, the wall chasing machine is used to create slots and grooves in mineral materials,
such as concrete, brick and limestone, without the use of water.
Use only diamond cutting discs recommended by the manufacturer.
Safety instructions
Safe working with the machine is possible only if you read the user manual
through carefully and strictly follow the instructions contained in this manual.
In addition, also follow the general safety instructions contained in the enclosed
booklet. Request technical training in the machine before using it for the first time.
If the power cable is damaged or severed during work, do not touch the cable but
disconnect the machine immediately from the mains. Never operate the machine
with a damaged power cable.
The machine must not become wet or be used in an environment exposed to
moisture.
rating.
the machine unattended – such as when performing setup/takedown work, in the event of
machine suddenly re-starting when unattended.
mage to switches, cables or plugs.
Check to confirm that the rpm specified on the disk is the same as or higher than the
machine rpm.
GB
19