Rhodius RH403S Originalbetriebsanleitung Seite 20

GB RH403S Original user manual
As an example, never use the face of a cutting disc – e.g. RHODIUS LD402/LD403 – for
grinding work.
structions.
your electrical tool.
ed, or damaged in any other way.
immediately if powerful vibrations occur or if you notice any other problems.
behind and away from the machine.
fessional.
When working with this machine, wear hearing protection
and a dust mask, plus safety goggles and protective gloves.
sparks/particles.
Caution! The tool rotates for a while after the machine is switched off.
See the enclosed booklet for additional safety instructions.
Electrical connection
Before starting work with the machine, check that the mains voltage/frequency matches the
details given on the rating plate.
Voltage differences of up to +6% or -10% are acceptable.
The machine has been designed as a Class II appliance.
an excessive loss of power, and cause the machine and/or cable to overheat.
The machine features a starting current limiter that prevents fast-acting circuit breakers from
being triggered accidentally.
Recommended minimum cross-sections and maximum cable lengths
Mains voltage
110V
230V
20
Cross-section in mm²
1.5
–
50 m
2.5
40 m
80 m