Cleaning & Maintenance - Siemens iQ 300 TB402850 Gebrauchsanleitung

Cleaning & Maintenance

See the leaflet sides
E Attention! Risk of burns!
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (7) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.
2. If the cloth is synthetic, it may melt due to the
high temperature on the soleplate, switch off
the steam and rub off any residue immediately
with a thickly folded, damp cotton cloth.
3. To keep the soleplate smooth, you should
avoid hard contact with metal objects. Never
use a scouring pad, or chemicals to clean the
soleplate.
Multiple descaling system
antiCalc

See the leaflet sides
a self-clean
Each time you use the steam regulator (3), the
"self-clean" system cleans the mechanism of
scale deposits.
B calc'nClean
The "calc'nClean" function helps to remove scale
particles out of the steam chamber. Use this
function approximately every 2 weeks if the
water in your area is very hard.
1 Unplug the iron from the mains socket, set
the steam regulator (3) to the
and fill the water tank (11) with water.
2 Set the temperature control (12) to the "max"
position and plug in the iron.
3 After the necessary warm-up period, the pilot
light (13) goes out. Then, unplug the iron
(very important!).
4 Hold the iron over a sink. Press the "clean"
button (10) and shake the iron until
approximately one third of the water capacity
of the tank is evaporated. Boiling water and
steam will come out, carrying scale or
deposits that might be there.
16
S I E ME NS
5 Release the "clean" button, and gently shake
6 Repeat the steps 4 and 5 three times until the
7 Then plug the iron in and heat it up again until
8 Unplug the iron and let the soleplate (7) cool
C
For deep descaling, it is recommended to use
the descaling liquid especially developed by
Siemens. This procedure should be carried out
every 3 months.
1. Fill the water tank (11) with tap water mixed
with a measure (25 ml) of the descaling liquid
(16*).
2. Then follow the procedure described above in
section "calc'nClean" (steps 2 to 8).
The descaling liquid may be purchased from our
after-sales service or specialist shops.
Name of accessory: TDZ1101
D
The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the "anti-calc" cartridge
cannot remove all of the scale that is produced
naturally over time.
position
[ ]
the iron for some seconds.
tank is empty.
the remaining water has evaporated.
Push the "clean" button a few times more to
clean the valve.
down. Wipe the soleplate with a damp cotton
cloth only.
"calc'nClean" with descaling liquid *
anti-calc
* Model dependent