Technical Data; Inserting/Replacing The Batteries - Bosch D-tect 150 SV Professional Originalbetriebsanleitung

OBJ_BUCH-1478-002.book Page 15 Friday, March 4, 2016 12:24 PM
4 Battery lid
5 Latch of battery lid
6 Handle
7 Maintenance flap
8 Serial number
9 Sensor area
10 Selection button, right
11 Start button
Start
12 Selection button, left
13 Audio signal button
Setup
14 Setup button
15 On/Off button
16 Display
17 LED
18 Protective pouch
The accessories illustrated or described are not included as stand-
ard delivery.
Display Elements
a Audio signal indicator
b Battery indicator
c Sensor-range indicator
d Area already detected
e Measuring scale for object depth
f Area not yet detected
g Outer edges, to be marked left and right via marking
aid 3
h Operating-mode indication
i Black: Found object within the sensor range
j Grey: Found object outside of the sensor range
k Centre line, corresponds with the marking aid 1
l Indication of the object depth
m Indication of the object material
n "Live" wire indicator

Technical Data

Universal Detector
Article number
Measuring accuracy to the object
2)
centre a
Accuracy of the displayed object
2)
depth b
– in dry concrete
– in wet concrete
Minimum distance between two
2)
neighbouring objects c
Operating temperature
Storage temperature
Batteries
Rechargeable batteries
Bosch Power Tools
Universal Detector
Operating time, approx.
– Batteries (alkali-manganese)
– Rechargeable
batteries (2500 mAh)
Degree of protection
Dimensions
Weight according to EPTA-Procedure
01:2014
1) Depending on size and type of object as well as material
and condition of the base material
2) See graphic
a
 In terms of accuracy and scanning depth, the mea-
surement result can be inferior in case of unfavoura-
ble surface quality of the base material.
The measuring tool can be clearly identified with the serial
number 8 on the type plate.
Assembly

Inserting/Replacing the Batteries

To open the battery lid 4, press the latch 5 in the direction of
the arrow and remove the battery lid. Insert the batteries/re-
chargeable batteries. When inserting, pay attention to the
correct polarity according to the representation on the inside
of the battery compartment.
The battery indicator b in the upper status line on the display
D-tect 150 SV
16 indicates the charge condition of the batteries/rechargea-
3 601 K10 008
ble batteries.
Note: Pay attention to the changing battery symbol so that
1)
±5 mm
the batteries/rechargeable batteries are replaced in time.
Please change batteries
1)
±5 mm
1)
±10 mm
1)
4 cm
–10 ... +50 °C
possible. Change the batteries/rechargeable batteries.
–20 ... +70 °C
To remove the batteries/rechargeable batteries, press on the
4 x 1.5 V LR06 (AA)
rear end of a battery as indicated in the figure on the battery
4 x 1.2 V HR06 (AA)
lid ( ). The front end of the battery/rechargeable battery is
released from the battery compartment ( ), so that the bat-
tery/rechargeable battery can easily be removed.
English | 15
D-tect 150 SV
IP 54 (dust and
splash water
protected)
22 x 9.7 x 12 cm
0.65 kg
c
b
When the "Please change
batteries" warning indica-
tion is indicated on the dis-
play 16, the settings are
saved and the measuring tool
switches off automatically.
Measurements are no longer
1 609 92A 26Y | (4.3.16)
5 h
7 h