Inhaltsverzeichnis
Werbung
4
CHEEK PAD FITTING
4.1 Insert the chin strap into the appropriate space on the cheek pad; insert the flap on the front of the
cheek pad into the seat of the inner chin guard (Fig. 3 and 4).
4.2 At the same time insert the cheek pad fastening button into liner eyelet and hook it to the EPS sup-
port (Fig. 7).
4.3 Repeat the previous operations for the right cheek pad.
WARNING!!!
-
If your helmet is equipped with the D-Ring retention system, pull it down as indicated in the
attached D-Ring label.
-
After each removal or restoring of the comfort padding, check the comfort by wearing the helmet
and, if necessary, repeat the steps described above.
-
Remove the padding only when cleaning or washing is required.
-
Never use the helmet if the inner comfort padding and the cheek pads have not been correctly and
completely fitted.
-
Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
-
Rinse with cold water and allow drying at room temperature, away from direct sunlight.
-
The inner polystyrene is an easily deformable material. It is apt to change or get partially destroyed
to help absorb shocks.
-
Clean it with a wet cloth and allow it to dry at room temperature away from direct sunlight.
-
Do not modify or alter the helmet's internal polystyrene components in any way.
-
Never machine-wash the inner comfort padding.
-
Never use tools or equipment of any sort to carry out the steps described above.
•
(Available as standard or optional accessory)
1
PINLOCK
®
INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment external
levers are turned inwards.
1.3 Place the Pinlock
inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock
1.5 Widen the visor and fasten the other side of the Pinlock
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors are correc-
tly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simultaneously
upwards to increase the stretch (Fig. 10). This operation must be carried out gradually. The maximum
stretch is achieved when the pin adjustment external levers are turned outwards.
WARNING!
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be replaced.
®
inner visor on the visor. WARNING: The silicone-sealed profile of the Pinlock
®
inner visor on one of the visor pins and hold it in position (Fig. 8).
®
inner visor to the second pin (Fig. 9).
®
inner visor and check that the entire silicone-sealed
10
®
Werbung
Inhaltsverzeichnis
