Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Attachment; Dmx-512 Connection / Connection Between Fixtures - EuroLite LED T500 Bedienungsanleitung

Rgb color changer
Vorschau ausblenden Andere Handbücher für LED T500:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the mounting brackets of the device, there are the holes for the installation.
Step 2: Hold the mounting brackets with the device onto the location where it is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the mounting brackets in the desired position and tighten them.
Adjust the desired inclination-angle via the mounting brackets and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Attention: After mounting the luminaries in the desired location, be sure to tighten the screw on the
underside of the mounting brackets with an imbus key. This prevents a possible slipping of the device.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Permanent installation is recommended!
DANGER TO LIFE!
the fixtures will not work at all, or will not work properly.
15/35
00028142.DOC, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Led t1000

Inhaltsverzeichnis