Fitting The Sprinkler Insert - perrot hydra m Bedienungsanleitung

7.2

Fitting the sprinkler insert

 Fit O-ring onto flange and lightly grease for easier assembly.
 Fit sprinkler module inside housing.
Guide ribs
 Push flange down as far as it will go.
 Fit retaining ring.
 Unclip snap-fit lid from the housing.
 Check sprinkler is working properly as per point's 5b-5e.
TDP062d+e.doc
Perrot REGNERBAU CALW GmbH
Ensure correct alignment.
Retaining ring must be fully inserted into the slot.
Rev. 27.06.2013
Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : perrot@perrot.de / E-mail Konstruktion : technik@perrot.de
Guide housing
Sprinkler
insert
Seite/Page 34 / 42