Adjusting The Inlet Nozzle - perrot hydra m Bedienungsanleitung

 Take off sprinkler head cover by levering the cover up at the notch using a small
screwdriver.
 Rotate nozzle to the left using pliers and then pull out.
 Optionally the sprinkler can be assembled with a tail nozzle. This nozzle can be
refitted or/and also closed with a corresponding plug.
 Put O-ring over the new nozzle
and, reversing the procedure, re-install in the sprinkler head.

Fit cover into sprinkler head's snap-in connection by first pushing it as far as it will
go against the side opposite the nozzle and then snapping it completely into place on
the nozzle side.
7.1

Adjusting the inlet nozzle

The recommended rotational speed is maintained by correctly adjusting the inlet nozzle.
Adjust as follows:
 Take off inlet nozzle and filter together by using a screwdriver to lever up the inlet
nozzle at the notch.
TDP062d+e.doc
Perrot REGNERBAU CALW GmbH
Rev. 27.06.2013
Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : +49-7051-162-0 / Fax : +49-7051-162–133
E-mail : perrot@perrot.de / E-mail Konstruktion : technik@perrot.de
O-Ring
Nozzle
Seite/Page 32 / 42