Operation; Audio Player Operation - Omnitronic VFM 208AP Bedienungsanleitung

7 7 7 7

OPERATION

1
Prior to switching on, turn the control MASTER LEVEL to minimum to avoid a possible switching-on
noise. Then switch on the speaker system with the power switch. The POWER indicator lights.
2
Turn up the control MASTER LEVEL so that the mixing ration of the signal sources can be adjusted in
an optimum way.
3
Use the button LINE/MP3 to define which signal source is mixed to the master signal: button pressed:
signal of the built-in audio player, button not pressed = signal of the jacks LINE INPUT.
4
Adjust the desired volume ratio for the signal sources with the level controls MIC LEVEL and LINE/MP3
LEVEL.
5
Adjust the desired sound with the tone controls. By adjusting the tone controls, the high frequencies
(control HI) and the low frequencies (control LOW) can be boosted or attenuated. With the controls in
mid-position, the frequency response is not affected.
6
Adjust the definite level of the overall volume with the control MASTER LEVEL. In case of overload, the
CLIP indicator lights up. In this case, reduce the volume correspondingly.
7
When operating the speaker system, please make sure that the loudspeakers always sound well. When
distortions can be heard, either the amplifier or the loudspeakers are overloaded. Overloads can quickly
lead to amplifier or speaker damage. In order to avoid damage, please reduce the volume immediately
when distortions can be heard. When speaker systems are destroyed by overload, the guarantee
becomes void. Always check the sound pressure level with a meter in order to keep to the threshold.
8
After operation, set the control MASTER LEVEL to minimum, then switch off the speaker system with
the power switch. The power indicator extinguishes.

Audio Player Operation

For models VFM-...AP with integrated audio player only.
1
Engage the button LINE/MP3 to assign the signal of the audio player to the master signal.
2
Insert a USB device into the USB port and/or a memory card into the card slot.
3
After loading a data carrier, it is selected as the playback medium and the playback will start
automatically. The display indicates "► ". During the playback, the display indicates the elapsed time of
the current title in minutes and seconds. Additionally, the file name will be scrolling across the display.
4
Adjust the desired volume for the audio player with the LINE/MP3 LEVEL control.
5
To interrupt the playback, press the button [► ]. The display indicates " ". To stop the playback, press
the button [ ]. The display indicates " ". After pressing the button [► ], playback will start from the
beginning of the title.
6
By short actuation of the buttons [
long actuation of the buttons, fast forward and reverse is activated.
7
With the button [
• indication "NOR": normal play
• indication "RALL": continuous repeat of all titles of the data carrier (basic setting)
• indication "RONE": continuous repeat of the selected title
• indication "FOLD": continuous repeat of the selected folder (not available)
• indication "RAN": the titles are played in random order
8
To remove a USB device, disconnect it from the USB port. To eject a memory card, slightly press it into
the slot until it comes out and can be removed. Prior to removing a device, always terminate the
playback with the buttons [►II] or [ ]. Otherwise damage or loss of data may occur.
] and [
], you can activate random play and repeat functions.
] you can skip titles in forward or backward direction. By
24