Renkforce 1404207 Bedienungsanleitung Seite 30

AUTO
This key activates the automatic mode.
Press the AUTO key (Pr00 is activated). Use the numeric keys (Pr01-Pr10), or the JUMP key (Pr01-PR16)
to select the appropriate program. With the +/- keys is selected the desired speed of the program se-
quence. The change in the speed takes place stepwise (S001/S064/S128/S192/S220/S240/S250/S255). With
the FLASH key can be adjusted the strobe speed of the white LEDs (FL01-FL04).
FADE
This key activates the FADE mode (Pr17-Pr18).
Press the FADE key. There are available two FADE programs. Press again the FADE key to select the sec-
ond program. With the +/- keys is selected the desired speed of the program sequence. The change in the
speed takes place stepwise (S001/S064/S128/S192/S220/S240/S250/S255).
COLOR (COLOUR)
Press this key to set the colour to red, green, blue or amber.
Press the COLOR key. The colour can be changed by pressing again the COLOR key. The direct selection
of the colours is performed with the Red, Green, Blue, and White key (Amber colour). Press the FLASH key
to activate the strobe function for the colours. Use the +/- keys to set the appropriate strobe speed (St01-
ST04). Press again the FLASH key to again deactivate the strobe function for the colours.
RED GREEN BLUE WHITE keys
With these keys you activate the red, green, blue, or amber colours (White key). See also the point COLOR.
DMX
Key to set the DMX address.
Press the DMX key. Set the DMX address via the +/- keys. Press and hold the + or - key to carry out accel-
erated the address change.
The DMX address is set on A001 if the DMX key is pressed longer than 2 seconds.
+/- key
With these keys you change the appropriate parameters in the individual operating modes.
JUMP
Key to select the individual automatic program.
Press repeatedly the JUMP key until the appropriate automatic program (Pr01-PR16) is executed.
FLASH
Key to activate the strobe function, respectively to select the strobe speed. This key is active in auto and
COLOR mode only.
30