Mounting Of Drag Chute - Skyline Zero Drag Racer Handbuch

ATTENTION: MIND CORRECT MOUNTING OF THE CHUTE!
Periodical packing of the rescue chutes should be taken for granted!
The connection line from
handle to inner container
HAS to be on the front
end of the inner container
(see illustration!).
Otherwise a correct
release of the chute
cannot be assured!
!!! ATTENTION!!!
At mounting the release handle, you have to mind following:
1. the connection line between handle and inner container HAS to be absolutely
LONGER than the connection line between handle and safety pins. That means:
while releasing, the handle MUST NOT be in tension, before the safety pins are
being pulled out of their loops. Rescue handle and inner container HAVE to be
compatible!
2. You have to ensure that the safety thread is unharmed and its set-up is correct.
The thread has to be controlled before each flight. This thread avoids
unintentional release (while launch) of the rescue chute. We recommend to using
only SKYLINE safety threads. If using non-proved threads, the
homologation/Gütesiegel expiries!

12. Mounting of Drag Chute

1. thread line into slider opening thru 10mm loop...
connection line
center
Release
handle
2. ... and loop-in!
skyline-flightgear.de
Rescue chute
Bridle
16 16