Indicators Message; Table 10. Indicators Message - Hitachi CP-SX5600W Bedienungsanleitung

T T R R O O U U B B L L
T T R R O O U U B B L L

Indicators Message

The POWER indicator, LAMP indicator, and TEMP indicator are lit and blank as follows. Take the
appropriate measures.

Table 10. Indicators Message

STANDBY/ON LAMP
indicator indicator
Lights
Turns off Turns off The Standby mode has been set.
orange
Blinks
Turns off Turns off Warming up. Please wait.
green
Lights
Turns off Turns off ON. Normal operation possible.
green
Blinks
Turns off Turns off Cooling. Please wait.
orange
Lights
Lights red
red
Blinks
Lights red
red
Lights red Turns off
NOTE *1) When the internal temperature becomes excessive power is switched OFF
automatically for safety reasons, and the indicator is extinguished. Set the power switch to [O] and
wait for 20 minutes until the equipment has cooled sufficiently.
E E S S H H O O O O T T
E E S S H H O O O O T T
TEMP
indicator
Lamp is not lit.
The interior of the equipment may be too hot. Switch
power OFF, wait 20 minutes until the equipment cools,
and check whether the ventilation openings are
Turns off
blocked, whether the air filter is dirty, or whether the
ambient temperature exceeds 35 °C. And switch power
ON again. Replace the lamp if the same problem
occurs.
Lamp or lamp cover is not found, or hasn't been fitted in
correctly.
Switch power OFF, and wait for 45 minutes until the
Turns off
equipment cools. Check fitting of the lamp and lamp
cover, and switch power ON again. Contact your dealer
if the same problem occurs again.
The cooling fan is not operating.
Switch power OFF, and wait for 20 minutes until the
Blinks
equipment cools. Check for foreign matters in the fan,
red
and switch power ON again. Contact your dealer if the
same problem occurs again.
I I N N G G ( ( c c o o
I I N N G G ( ( c c o o
Contents
n n t t i i n n u u e e d d
n n t t i i n n u u e e d d
ENGLISH-21 ENGLISH-21
) )
) )