Operations; Power On; Power Off - Hitachi CP-SX5600W Bedienungsanleitung

OPERATIONS

OPERATIONS
Power Switch
Lens cap

Power ON

1. Check that the power cord is connected correctly.
2. Set the power switch to [ | ]. The standby mode is selected, and the STANDBY/ON indicator is turned to orange.
3. Press the STANDBY/ON button
begins and the STANDBY/ON indicator blinks in green.
4. The STANDBY/ON indicator ceases blinking and turns to green when power is on. Remove the lens cap.
5. Adjust picture size using the Zoom Knob.
6. Adjust focus using the Focus Ring .

Power OFF

1. Press the STANDBY/ON button
"Power off?" will appear on the screen, and the message will disappear by any operation or no operation for
5 seconds. During this message indication, press the STANDBY/ON
is extinguished and lamp cooling begins. The STANDBY/ON indicator blinks orange during lamp cooling.
Pressing the STANDBY/ON button
2. The system assumes the Standby mode when cooling is complete, and the STANDBY/ON indicator ceases
blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3. The STANDBY/ON indicator is extinguished when power is off. Attach the lens cap.
Put the Lens cap to the lens properly. In order to do it, keep pushing two knobs on the lens cap, then fit
it to the lens holding the cap in horizontal position.
WARNING • Please read this manual, and the separate "SAFETY
INSTRUCTIONS" thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE Except in emergencies, follow the above-mentioned procedure for turning power off. If the
•
projector is used improperly, it may very difficult to turn off the projector caused by heating inside the
unit. And the reduction of life time of lamp and LCD panels will be caused by incorrect procedure.
• To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF.
Providing a RS-232C cable is connected, turn on the computer before the projector.
• When a projector continues projecting the same image, the image may remain as an afterimage. Please
do not project the image same for a long time.
STANDBY/ON Button
(STANDBY/ON Indicator)
Focus Ring
on the control panel or the remote control transmitter. Warm-up
on the control panel or the remote controller. Then,the message
has no effect while the STANDBY/ON indicator is blinking.
STANDBY/
ON Button
Zoom Knob
button again. The projector lamp
STANDBY/ON BLANK
LASER
VIDEO RGB
AUTO
MENU
KEYSTONE
MENU SELECT
RESET
POSITION
FREEZE PinP
MAGNIFY
MUTE
OFF
VOLUME
ENGLISH-9 ENGLISH-9