Indirect Measurement - UNI-T MIE0149 Bedienungsanleitung

Owner's manual
Operate the above steps repeatedly, the meter will add or reduce
cumulatively. The last step is cancelled.
Area
Press once. The symbol appears in the display.
Press again to take the second length measurement (e.g.
width). After taking the second measurement, the area/surface is
automatically calculated and displayed in the summary line. The
last individual measured value is indicated at the second line in the
display.
Volume
For volume measurements, push button twice until the
indicator for volume measurement appears in the display. After-
wards, press this button to measure the length. Press this
button for width. Press button to take the height,
After taking the third measurement, the volume is automatically
calculated and displayed. The last individual measured value is not
displayed.

Indirect measurement

When measuring heights that require the measurement of two or
EN
three measurements ,as following step:
Using 2 measurements
Press this button , the display shows. Aim at the upper
point (1) and trigger the measurement. After the first measurement,
the value is adopted.
21