What To Do If; Correcting Malfunctions - AEG Electrolux SANTO Z 9 18 40-5 i Gebrauchs- Und Einbauanweisung

What to do if ...

Correcting Malfunctions

A malfunction may be caused by only a minor fault that you can rectify
yourself using the following instructions. Do not perform any other work on
the appliance if the following information does not provide assistance in
your specific case.
Warning! Repairs to refrigerators/freezers may only be performed by quali-
fied service engineers. Improper repairs can give rise to significant hazards
for the user. If your appliance needs repairing, please contact your speciali-
st dealer or our Customer Service.
Symptom
Appliance does not work.
Appliance cools too much.
The refrigerator and/or
freezer compartment tem-
perature is insufficient.
Interior lighting does not
work.
The compressor does not
start immediately
pressing the TURBO COOL-
MATIC button, or
changing the temperature
setting.
Possible Cause
Appliance is not switched
on.
Mains plug is not plugged
in or is loose.
Fuse has blown or is
defective
Socket is defective.
Temperature is set too
cold.
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Light bulb is defective.
after
This is normal, no error has
after occurred.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to
be corrected by an electri-
cian.
Press „+" (WARMER) but-
ton.
Please look in the "Starting
up and Temperatur regula-
tion" section.
Open the door only as long
as necessary.
Press TURBO COOLMATIC
button.
Please look in the "Installa-
tion location" section.
Please look in the "Changing
the light bulb" section.
The compressor starts after
a period of time.
27