Starting Up - Setting The Temperature - AEG Electrolux SANTO Z 9 18 40-5 i Gebrauchs- Und Einbauanweisung

Starting Up - Setting the Temperature

1. Plug the mains plug into the mains socket.
2. Press ON/OFF button. The green mains pilot indicator illuminates. The
appliances start.
3. Press either the „C" or „E" button. The temperature display switches over and
the DESIRED temperature currently set flashes on the temperature display.
4. Set the required temperature by pressing the „C" or „E" buttons (see section
"Temperature setting buttons"). The temperature display will immediately
show the changed setting. Each time the button is pressed the temperatu-
re is adjusted by 1 °C.
From a food safety point of view +5 °C should be considered sufficiently
cold for storing food in the fridge.
5. Once the required temperature has been set, after a short period (approx. 5
sec.) the temperature display will change and again indicate the current
ACTUAL temperature inside the fridge. The display will change from flashing
to continuous illumination.
Information! When the setting is changed, the compressor does not start
immediately if automatic defrosting is currently taking place. As the stora-
ge temperature within the fridge is reached quickly you can store food
immediately after switching on.
TURBOCOOLMATIC
The TURBOCOOLMATIC function is suited for quick cooling of large quanti-
ties of goods in the refrigerator.
1. The TURBOCOOLMATIC function is switched on by pressing the TURBO-
COOLMATIC button. The yellow light illuminates.
The TURBOCOOLMATIC function now provides for intensive cooling. A DESI-
RED temperature of +3°C is automatically selected. The TURBOCOOLMATIC
function is ended automatically after a period of 6 hours.
2. The TURBOCOOLMATIC function can be ended manually at any time by
pressing the TURBOCOOLMATIC button again. The yellow light goes out.
12