Preparation For Use - Power Craft 11940 Gebrauchsanweisung

Preparation for use

Remove the flange nut and outer flange
from the spindle (a). Attach the disc shield
(6) to the spindle and fit the second flange
(c) on the spindle. Move the shield to the
desired position, and secure it with the
screw (b). The shield must be positioned
to protect the user if the disc (7) shatters
during use. Replace the outer flange and
flange nut on the spindle.
Check that the spindle lock (8) is not locked
and that the disc can freely rotate.
GB
Fit the side handle (5) on the left or right
side of the grinder, depending on whether
it is to be used by a left- or right-handed
person. Check that the handle is securely
fitted.
Switch the grinder on using the on/off
button (3), and let it run for 30 seconds to
check that it is working correctly and that
there are no abormal vibrations. Stop the
grinder immediately if heavy vibration
occurs, and investigate the cause.
24
Fitting grinding disc
Depress and hold down the spindle lock to
secure the spindle. Turn the shaft (d), until it
locks. Remove the flange nut (e) and outer
flange using the special wrench provided
(f ).
Fit the desired disc (7) on the spindle and
replace the outer flange and flange nut.
Release the spindle lock.
Use
Hold the handle (1) and side handle
firmly and switch on by pressing (2) and
(3) simultaneously. Avoid blocking the
ventilation slots (9) with your hand, as this
may cause the grinder to overheat. Let the
disc reach full speed.
Apply the grinder to the item. Maximum
effect is achieved when the grinder is held
at an angle of 15-30° in relation to the item.