Switching Off; Display; Temperature Regulation; Coolmatic Function - AEG Electrolux SK98840-6I Gebrauchsanleitung

22
Control panel

Switching off

1. Keep ON/OFF switch pressed for more than 5 seconds.
2. After that, a countdown of the temperature from -3 -2 -1 will be shown. When "1"
appears the appliance is turned off. The temperature indicator switches off. The Pilot
light switches off.

Display

The Temperature Display shows the following information:
• During normal operation the Display shows the set temperature.
• During temperature adjusting operation, the set (DESIRED) temperature is indicated by
flashing numbers.

Temperature regulation

The temperature can be adjusted between +2 °C and +8 °C.
Set default temperature +5 °C, it is optimal for food storage.
The set temperature of the fridge may be adjusted
by pressing the Temperature Regulator Buttons.
By pressing any of two buttons the DESIRED tem-
perature modified by 1 °C.
The Temperature Display shows the set tempera-
ture.
The set temperature will be reached within 24 hours.
After a power failure or long period out of use the set temperature remains stored.
For a correct storage of food and drink the +5 °C temperature should be set.
However, the exact setting should be chosen keeping in mind that the temperature inside
the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is high or the appliance is fully loaded, and the appliance is set
to the lowest temperatures, it may run continuously causing frost to form on the rear wall.
In this case the Temperature Regulator must be set to a higher temperature to allow auto-
matic defrosting and therefore reduced energy consumption.

COOLMATIC function

The COOLMATIC function is suitable for quick cooling of large quantities of goods in the
refrigerator.
To activate the function, do these steps:
1. Press the COOLMATIC switch.
2. The COOLMATIC indicator will light up.
3. A temperature setting of +2°C is automatically selected.
To deactivate the function, do these steps: