Changing The Light Bulb - AEG SANTO SK91000-5I Gebrauchsanweisung

Symptom
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
Water on the floor or on
storage shelves.
Temperature cannot be set
The compressor does not
start immediately after
pressing the COOLMATIC
button, or after changing
the temperature setting.

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or disconnect from the
mains supply.
Light bulb data: 220-240 V,
1. To switch off, press the ON/OFF button
until the mains power light extinguish-
es.
2. Unplug the mains plug.
3. To change the light bulb,
rear hook and at the same time slide
the light bulb cover in the direction
indicated by the arrow.
Possible Cause
Light bulb is defective.
Door seal is not air tight
(possibly after reversing
the door).
Water drain hole is
blocked.
COOLMATIC function
switched on.
This is normal, no error has
occurred.
max. 25 W
press on the
What to do if...
Remedy
Please look in the "Changing
the light bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
See the "Cleaning and
Care" section.
Switch off COOLMATIC
manually, or wait to set
the temperature until the
function has reset auto-
matically (refer also to
COOLMATIC section).
The compressor starts after
a period of time.
43