Replacing The Lamp; Closing The Door; Technical Data - AEG Electrolux SKZ81200F0 Benutzerinformation

Problem
Water flows on the rear
plate of the refrigerator.
Temperature cannot be
set .
The temperature in the ap-
pliance is too low/high.
The temperature in the re-
frigerator is too high.

Replacing the lamp

The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
COOLMATIC function switched
on.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Height
Width
Depth
Technical data
Solution
This is correct.
Switch off COOLMATIC manually,
or wait to set the temperature
until the function has reset auto-
matically. Refer to "COOLMATIC
function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
1225 mm
560 mm
550 mm
17