AEG Electrolux S63800KMX0 Benutzerinformation Seite 35

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the COOLMATIC
switch, or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
Upper or lower square is
shown in the temperature
Display.
Possible cause
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
An error has occurred in meas-
uring the temperature.
What to do if...
Solution
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a peri-
od of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
35