Safety Precautions - PeakTech 1630 Bedienungsanleitung

1. Safety Precautions

This product complies with the requirements of the following European
Community Directives: 89/336/EC (Electromagnetic Compatibility) and
73/23/EC (Low Voltage) as amended by 93/68/EC (CE-Marking).
Overvoltage category II 600V; pollution degree 2.
CAT I: For signal level, telecommunication, electronic with small
transient over voltage
CAT II: For local level, appliances, main wall outlets, portable
equipment
CAT III: Distribution level, fixed installation, with smaller transient
over-voltages than CAT IV.
CAT IV: Units and installations, which are supplied overhead lines,
which are stand in a risk of persuade of a lightning, i.e. main-
switches on current input, over-voltage-diverter, current use
counter.
To ensure safe operation of the equipment and eliminate the danger of
serious injury due to short-circuits (arcing), the following safety
precautions must be observed.
Damages resulting from failure to observe these safety precautions are
exempt from any legal claims whatever.
* Do not use this instrument for high-energy industrial installation
measurement. This instrument is intended for use in installation
over-voltage category II.
* Do not exceed the maximum permissible input ratings (danger of
serious injury and/or destruction of the equipment).
* Disconnect test leads or probe from the measuring circuit before
switching modes or functions.
* Check test leads and probes for faulty insulation or bare wires
before connection to the equipment.
* Never touch the tips of the test leads or probe.
* Comply with the warning labels and other info on the equipment.
-14-
RICHTIG
5.3. Frequenzmessungen (nur P 1630)
1. Gerät mit Funktionswahlschalter (3) auf die Position Frequenz-
messungen „Hz" umschalten.
2. Zange durch Drücken des Zangenöffners (6) öffnen und Leiter in
die Zange nehmen.
Wichtig ! Immer nur einen Leiter in die Zange nehmen.
3. Zangenöffner loslassen und Messwert in der LCD-Anzeige
ablesen.
FALSCH
-11-