Progress PIX1540X Benutzerinformation Seite 19

German
degrees
(°dH)
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to "Setting and
starting a programme".
2. Press and hold at the same time button
and button
cators of buttons
start to flash.
3. Press button
Filling the salt container
Water hardness
French mmol/l
degrees
(°fH)
< 7 < 0.7
until the indi-
,
.
Clarke
degrees
< 5
• The indicators of buttons
and
• The indicator of button
ues to flash.
• The display shows the current setting
of the water softener, e.g.
5.
4. Press button
and
change the setting.
5. Deactivate the appliance to confirm the
setting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the
salt container.
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after
you fill the salt container, start a pro-
gramme.
progress 19
Water softener
adjustment
Level
2)
1
go off.
again and again to
contin-
= level