Victron energy Phoenix Anleitung Seite 4

2. Description
VE.Direct communication port
The VE.Direct port can be connected to:
• A computer (VE.Direct to USB interface cable needed)
• Apple and Android smartphones, tablets and other devices (VE.Direct to Bluetooth
Smart dongle needed)
Fully configurable
• Low battery voltage alarm trip and reset levels
• Low battery voltage cut-off and restart levels
• Output voltage 210 - 245V
• Frequency 50 Hz or 60 Hz
• ECO mode on/off and ECO mode sense level
Monitoring
Battery voltage and current, AC Output voltage and current, alarms
Proven reliability
The full bridge with toroidal transformer topology has proven its reliability over many
years.
The inverters are short circuit proof and protected against overheating, whether due
to overload or high ambient temperature.
High start-up power
Needed to start loads such as power converters for LED lamps, filament lamps or
electric tools.
ECO mode
When in ECO mode, the inverter will switch to standby when the load decreases
below a preset value. It will switch on and check every few seconds, adjustable, if the
load has increased again.
Remote on/off connector
A remote on/off switch can be connected to a two pole connector or between battery
plus and the left hand contact of the two pole connector.
LED diagnosis
A red and a green LED indicate inverter operation and status of the different
protections.
Available with different output sockets
Schuko, UK (BS-1363), AU/NZ (3112) or IEC-320 (male plug included)
2