Replacing The Lamp; Closing The Door; Technical Data - AEG Electrolux SANTO D 9 12 40-5i Benutzerinformation

32

Technical data

Problem

Replacing the lamp

1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new lamp
of the same power (the maximum power
is shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the lamp
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.
Technical data
Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
There is no cold air circulation in
the appliance.
Height
Width
Depth
Solution
Make sure that there is cold air
circulation in the appliance.
1225 mm
560 mm
550 mm
20 h