Before Beginning Installation; Fixing - AEG DD 6590 Benutzerinformation

Before beginning installation

First decide which functioning
version is better for you.
If you decide to use the hood in
exhausting version we suggest to
position the upper section of the
chimney so that the oulet slots are
not visible once installation has
ended, on the contrary if is decided
to use the hood in recycling version
BE SURE that the side with slots is
up (see also A-B-C sequence on on
Fig. 6).

Fixing

• Trace the median line on the wall, choose a comfortable height for
the user and trace it on the wall to make montage easier (1-2).
• Determine the X and Y dimensions and mark the position of the two
holes with a pencil. Then carry out the perforation (2 x Ø 12 mm);
insert the two hooks with dowels (3).
• Remove the fat filter (4), hang the hood up, adjust its horizontal po-
sition with the adjustment screws (5).
• Mark the position of the 2/4 holes on the wall (6).
Remove the hood and carry out the perforation (2/4 x Ø 8 mm). In-
sert the dowels into the holes.
• Fix the flue support bracket (7A – Suction version) or the deflector
(7F – Filtering version) with the Ø 8 mm dowels and the Ø 5x45
mm screws at 3-4 mm distance from the ceiling with the hood cen-
tred and perfectly horizontal.
• Hand the hood up again, fixing it definitively (8) with the screws (2/4
x Ø 5x45 mm).
• Fix the reduction tube (9) above the hood with two Ø 3 x 9 mm
screws.
• Use a tube long enough to reach the outside (10) or the deflector
(7F – Filtering version).
• Connect the electricity (11) (see "Electric connection" chapter).
• Apply the flue (12) and fix it to the support bracket with 2 Ø 3x9 mm
screws or to the deflector with 4 Ø 3.5x13 mm screws. Let the lower
part of the flue slide down and apply the upper part over the hood
(13).
• Mount the fat filter.
60
A
C - OK!
Fig. 6
B
180°