Velleman ZLLPIR Bedienungsanleitung Seite 4

4. Features
• low power consumption
• PIR sensor technology
• 3 modes: ON, AUTO or OFF
5. Installation and operation
Refer to the drawing on page 2 of this manual.
• Make sure batteries are installed in the device.
• Mount the lamp in a dry location. Avoid places where temperature
changes frequently, e.g. near air conditioners or heating devices. Also
avoid moving obstructions or moving objects in the detection field of
the sensor [B].
• The lamp has a 3-position switch [C].
• Move the switch to the ON position to switch the LEDs continuously
on.
• In the AUTO position, the LEDs will switch on when movement is
detected. They will remain on for about 25~30s after last movement
was seen.
• Move the switch to the OFF position to switch the device off.
6. Batteries
• Open the battery compartment on the back of the device.
• Insert 4 new type AA batteries (LR6C) with the right polarity as
indicated inside the battery compartment.
• When replacing batteries, always use 4 new batteries of the same
brand and capacity.
• Close the battery compartment.
WARNING: handle batteries with care, observe
warnings on battery casing. Dispose of batteries in
accordance with local regulations.
Keep the battery away from children.
7. Troubleshooting
Check for obstructions in front of the sensor.
Low sensor
Check whether the operating temperature is <30°C.
sensitivity
Verify whether movement is within the detection range.
Check if there is continuous movement present inside
LEDs don't
detection range.
switch off in
Check if batteries are according to specifications.
AUTO mode
Check if device is subjected to rapid temperature changes.
00 (06/11/2008)
ZLLPIR
4
®
VELLEMAN