Electrolux FAVORIT 30010 I Benutzerinformation Seite 48

48
What to do if...
Fault code and malfunction
• continuous flashing of the START/RESET in-
dicator light
• 2 flashes of the end of programme indica-
tor light
The dishwasher will not drain
• continuous flashing of the START/RESET in-
dicator light
• 3 flashes of the end of programme indica-
tor light
• The programme does not start
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
Possible cause and solution
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly
laid or it is bent or squashed
Check the water drain hose connection
• Anti-flood device is activated
Close the water tap and contact your local Serv-
ice Force Center.
• The dishwasher's door has not been properly
closed
Close the door
• The main plug is not plugged in
Insert the main plug
• The fuse has blown out in the household fuse
box
Replace the fuse
• Delay start has been set
If dishes are to be washed immediately, cancel
the delay start