Ideen Welt LS-201 Bedienungsanleitung Seite 19

WARNING!
• Do not switch on the device if the shaving head has been removed.
• Do not use any aggressive or abrasive detergents.
• Only clean the shaving head and cutter block under cold, running tap
water. Do not use warm water, detergents or other admixtures.
• Do not exert too much pressure on the shaving foil. It is thin and
easily damaged.
• Only use the cleaning brush to clean the cutter block, never to clean
the shaving foil.
Replacing the cutter block
1. Touch below a blade of long hair trimmer, e.g. using your
fingernails and pull off the cutter block (Fig. 4).
2. The cutter block only fits correctly at one position. Therefore the
alignment nose in the shaver head must fit in the slot of the cutter
block (Fig. 5). In this position, the long hair trimmer blade with
straight edge is facing forward as shown in Fig. 6.
3. Push the cutter block down into the shaving head. Make sure both
sides latched in place correctly.
Fig. 4
LS-201_A6_160728.indb 19
Fig. 5
19
Fig. 6
28/7/16 2:06 PM