Inserting/Replacing The Remote Control Battery - Renkforce DB-L6F Bedienungsanleitung

Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Set up the fog machine under observation of the above safety notes.
• The operating position is horizontal or vertical.

8. Inserting/Replacing the Remote Control Battery

Keep batteries out of reach of children.
Observe correct polarity when inserting the battery.
Remove the battery when the device is not in use for extended periods of time.
Leaking or damaged batteries may cause chemical burns to skin when touched. Use adequate
protective gloves in this case.
Do not short-circuit the battery and do not throw it into fire. It also must not be recharged. Dan-
ger of explosion.
At initial commissioning, the battery of the remote control may be protected from discharge by
an isolation film. Remove this film before use by pulling it out of the remote control's battery
compartment.
• Pull the battery holder out at the bottom of the remote control.
• If required, remove the discharged battery and insert a new 3 V-Lithium button cell CR2025. The correct
polarity is indicated on the rear of the remote control.
• Insert the batteries in the remote control again.
• If the remote control no longer functions properly, the battery is discharged and must be replaced with a
new one of the same type.
28