4:3 Auto Aspect; Colour System; Pip Position - JVC InteriArt AV42PD20ES Bedienungsanleitung

AUTO:
The TV will automatically adjust the level of the DigiPure
effect to match the amount of noise in the picture, giving the
best possible picture.
MIN:
The level of DigiPure effect is set to the minimum. When
you set the DigiPure Pro function to AUTO and notice some
noise, change the setting from AUTO to MIN.
• The MIN setting is not suitable for high-quality pictures
which contain very little noise.
MAX:
The level of DigiPure effect is set to the maximum. If you
set the DigiPure Pro function to AUTO but feel that the
original picture quality has not been reproduced fully,
change the setting from AUTO to MAX.
• The MAX setting is not suitable for low-quality pictures
which contain a lot of noise.
OFF:
The DigiPure Pro function is turned off.

COLOUR SYSTEM

The colour system is chosen automatically. However, if the
picture is not clear or no colour appears, choose the colour
system manually.
1 Choose COLOUR SYSTEM. Then press the a
button
The sub-menu of the COLOUR SYSTEM function
appears.
COLOUR SYSTEM
MAIN SUB
PAL AUTO
BACK
TV OK
D0016-EN
2 Press the 5 5 buttons to choose MAIN or SUB
5 5
MAIN:
You can change the colour system of the main-picture.
SUB:
You can change the colour system of the sub-picture.
• Choose MAIN when a sub-picture is not displayed.
3 Press the 6 6 6 buttons to choose the 6
appropriate colour system. Then press the a
button
PAL:
PAL system
SECAM:
SECAM system
NTSC 3.58:
NTSC 3.58 MHz system
NTSC 4.43:
NTSC 4.43 MHz system
AUTO:
This function detects a colour system from the input
signal. You can only use this when you are viewing a
picture from programme number PR 0 (AV), or an EXT
terminal.
• The AUTO function may not work properly if you
have poor signal quality. If the picture is abnormal in
the AUTO function, choose another colour system
manually.
• You cannot choose NTSC 3.58 or NTSC 4.43 for
programme numbers PR 0 (AV) to PR 99.

4:3 AUTO ASPECT

You can choose one of three ZOOM modes, REGULAR,
PANORAMIC or 14:9 ZOOM, as the ZOOM mode for the
normal picture (4:3 aspect ratio).
1 Choose 4:3 AUTO ASPECT then press the a
button
4:3 AUTO ASPECT
PANORAMIC
REGULAR
14:9 ZOOM
BACK
TV OK
D0017-EN
2 Press the 6 6 buttons to choose a ZOOM mode
6 6

PIP POSITION

You can choose one of four positions for the sub-picture.
1 Press the 6 6 buttons to choose PIP POSITION.
6 6
Then press the a button
The PIP POSITION menu appears.
PIP POSITION
BACK
TV OK
D0053-EN
2 Press the 5 5 buttons to choose the position.
5 5
Then press the a button
Using the TV's menu
a a a
17