Using The Appliance; Brewing Coffee - Philips HD7448 Bedienungsanleitung

3 Switch the appliance on by pressing the on/off switch (fig. 4).
The light goes on (HD7448 only).
Let the appliance run until the water tank is completely empty.
4 Switch the appliance off when all the water is in the jug.
5 Let the appliance cool down for at least 3 minutes before you
start brewing coffee.

Using the appliance

Brewing coffee

1 Open the lid (fig. 2).
2 Fill the water tank fresh cold with water (fig. 5).
The graduations on the left are for large cups (120 ml).
The graduations on the right are for small cups (80 ml).
3 Close the lid.
4 Place the jug on the hotplate.
Make sure you place the jug properly on the hotplate.
If you don't place the jug properly on the hotplate, the drip stop will
B
prevent the coffee from flowing into the jug and the filter may overflow
as a result.
5 Open the filter holder (fig. 6).
6 Take a paper filter (type 1x4 or no. 4) and fold the sealed edges
to prevent tearing and folding.
In some countries this coffee maker comes with a permanent filter. In
that case you should not use paper filters.
7 Put the filter in the filter holder.
8 Put pre-ground coffee (filter-fine grind) in the filter (fig. 7).
For large cups: use one heaped measuring spoon of ground coffee for
each cup.
ENGLISH
7