Electromagnetic Fields (Emf); Preparing For Use; Using The Appliance - Philips HD7140 Bedienungsanleitung

EnglisH
6
important
Read this user manual carefully before you use the appliance and save it for future reference.
Check if the voltage indicated on the appliance corresponds to the local mains voltage before
,
you connect the appliance.
Do not use the appliance if the mains cord, the plug or the appliance itself is damaged.
,
If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised
,
by Philips or similarly qualified persons in order to avoid a hazard.
Keep the appliance and its cord out of the reach of children. Do not let the mains cord hang
,
over the edge of the table or worktop on which the appliance stands.
Do not place the appliance on a hot surface and do not let the mains cord come into contact
,
with hot surfaces.
Never immerse the appliance in water or any other liquid.
,
Never pour milk, coffee or tea into the water tank.
,
Unplug the appliance if problems occur during brewing and before you clean it.
,

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

Preparing for use

1 Place the appliance on a flat and stable surface.
 Put the plug in the wall socket.
 Wind excess cord clockwise round the cord storage facility at the back of the
appliance (Fig. 1).
Do not let the cord come into contact with hot surfaces.

Using the appliance

1 Fill the cup or cups you are going to use with fresh, cold water.
 Pour the water into the water tank (Fig. ).
Do not fill the water tank beyond the MAX indication.
 Put a paper filter (no. 101) in the filter holder. (Fig. 3)
Some types come with a permanent filter (Fig. 4).
,
Never use a permanent filter and a paper filter at the same time.
Note: You can also order the permanent filter separately (see chapter 'Ordering accessories').
4 Put ground coffee (filter-fine grind) in the filter (Fig. 5).
- If you grind the coffee beans yourself, do not grind them too finely.
- Take approx. two level measuring spoons of ground coffee for each cup when you use large
cups (for instance the cups that come with the appliance).
- Take one level measuring spoon of ground coffee for each cup when you are use smaller cups.
- You can adapt the amount of coffee to your own taste.
5 Place the cup or cups under the coffee spout (Fig. 6).
6 Press the button to switch on the appliance (Fig. 7).
The power-on light goes on.
Do not remove the cup or cups while the appliance is brewing!