Whirlpool AKR 019/IX Installationsanleitung Seite 7

DESCRIPTION OF HOOD
1
3
2
1. Control panel.
Light :
move the switch to the right or press the button to switch
on.
Extraction speed :
Move the switch to the right or press the next button to
increase extraction speed (or open the electric shutter )
2. Grease filter (the number of grease filters may vary,
depending on the model).
3. Grease filter handle.
4. Lamp covers (the number and position of lamps and/or
lamp covers may vary, depending on the model).
5. Telescopic flue.
6. Air vent (Filter version only)
Grease filters:
Metal grease filters have an unlimited life
and should be washed once a month
either by hand or in a dishwasher at a
low temperature and with a short cycle.
Washing in a dishwasher can cause
grease filters to turn white, but this in no
way affects efficiency.
Removing the filter: push the spring
release handle backwards (b) then
remove the filter downwards (a).
Wash the filter and leave it to dry, proceeding in reverse
order to refit it.
Carbon filters (filter hoods only):
Change the carbon filter every four months.
It cannot be washed or regenerated.
Fitting or replacing the carbon filter (filter hoods only).
1. Remove the grease filters.
2.Fit the filter/s over the motor: make sure the pins R on
the manifold match the slots S, then turn clockwise until
locked.
3. Refit the grease filters.
5019 300 01342
5
6
4
.
GB
D F NL
Replacing bulbs
Disconnect the appliance from the power supply.
Warning! Make sure lamps are cold before touching them.
1. Remove the clip that secures the lamp cover, then prise off
using a small screwdriver or other suitable tool.
2. Replace the damaged lamp with a halogen lamp 28W max.
(E14)
3. Refit the lamp cover and secure in place with the clip.
Note: the lamp can also be accessed by removing the grease
filters, but removing the lamp in this way is more difficult.
P I GR
E