Whirlpool WBA3327 NF IX Bedienungsanleitung Seite 4

If the appliance has the fan it can be equipped with the
antibacterial filter.
Remove it from the box (found in the crisper drawer (item
8) and insert into the cover of fan (item 2b).
The replacement procedure is attached with the filter.
CONTROL PANEL
1. "Fast Cooling" function
2. Indication of temperature settings
3. Temperature selection / "Fast Cooling" pushbutton
4. Internal light switch
TEMPERATURE SELECTION
Press the pushbutton on the control panel to adjust the
temperature.
Temperature selection pushbutton is used to set desired
temperature level, from warmest
coldest .
Pressing pushbutton setpoint will change cyclically.
Temperature set-point is done for both compartments at
one time – fridge and freezer.
At first plug-in of appliance factory set-point is chosen –
medium position.
Following table shows set-points level:
High temperature
Mid-high temperature
Middle temperature
Mid-low temperature
Low temperature
Legend Led ON
FUNCTIONS
FAST COOL
The use of this function is recommended to increase the
cooling speed when placing a very high quantity of food in
the refrigerator compartment by pressing and holding the
pushbutton on the control panel for 3 sec.
The Fast Cool (yellow LED) will turn on. The function is
automatically deactivated after 6 hours.
The Fast Cool function can be manually deactivated by
pressing and holding the same pushbutton on the control
panel for 3 sec., the yellow LED is off.
PRODUCT SHEET
through lower
Led OFF
D
Note:
- Fast Cool function should be also switched ON before
placing fresh food to be frozen in the freezer
compartment, in order to maximize the freezing capacity.
CLEANING
Regularly clean the appliance using a cloth and a solution of
warm water, with some soft detergent suitable for cleaning
the inside of the refrigerator compartment.
Do not use abrasive detergents or tools.
To ensure continuous and
correct flow of defrost water,
regularly clean the inside of
the draining hole on the back
of the refrigerator near the
fruit and vegetable drawer,
using the tool provided.
Before carrying out any cleaning or maintenance operation,
unplug the appliance or disconnect it from the power
supply.
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
to
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase is in
progress. The defrost water is automatically run into a
drain hole and collected in a container, where it evaporates.
DEFROSTING THE FREEZER COMPARTMENT
No Frost freezers provide chilled air circulation around the
storage areas and prevent the formation of ice, thereby
completely eliminating the need for defrosting. Frozen
items don't stick to the walls, labeling stays legible and
storage space remains neat and clear.
LED's LIGHTING
If the inside LED light is not working,
it must be replace by service.
Important:
The refrigerator compartment light
switches on when the refrigerator
door is opened. After 10 minutes of
door opening the light switches off.
FAILURE ALARMS
When the product is plugged in to the mains, during first
10 minutes of its performance, possible temperature
sensor failure will be displayed according to following table:
Legend Led OFF
The appliance will work preserving the food stored, but it
is necessary to contact after-sales service and provide alarm
code.
GB F I PL
Refrigerator Evaporator sensor failure
Refrigerator sensor failure
Refrigerator & Evaporator sensor failure
Led Flashing
GB