Using The Remote Control - Sharp AY-XP7HR Bedienungsanleitung

USING THE REMOTE CONTROL

LOADING BATTERIES
Use two size-AAA (R03) batteries.
1
Remove the remote control cover.
2
Insert batteries in the compartment,
making sure the ± and — polarities are
correctly a lign ed.
• The display indicates "AM 6:00" when batteries
are properly installed.
3
Reinstall the cover.
Remote
control cover
NOTE:
• The battery life is approximately one year in normal
use.
• When you replace the batteries, always change both
batteries, and make sure they are the same type.
• If the remote control does not operate properly after
replacing the batteries, take out the batteries and
reinstall them again after 30 seconds.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's signal
receiver window and press the desired button. The
unit generates a beep when it receives the signal.
• Make sure there is no curtain or other object
between the remote control and the unit.
• The remote control can send signals from up to 7
metres away.
CAUTION:
• Do not allow the signal receiver window to receive
• Using a fl uorescent lamp with a quick starter in the
• The unit can be affected by signals transmitted from
• Do not leave the remote control in direct sunlight
-
+
+
-
SET CURRENT CLOCK TIME
There are two clock modes: 12-hour mode and
24-hour mode.
Example: 5 o'clock in the afternoon
1
2
3
NOTE:
• The current time cannot be set when the timer is
E-4
strong direct sunlight, since it can adversely affect
its operation. If the signal receiver window is
exposed to direct sunlight, close a curtain to block
the light.
same room may interfere with transmission of the
signal.
the remote control of a television, VCR or other
equipment used in the same room.
or near a heater. Also, protect the unit and remote
control from moisture and shock which can
discolour or damage them.
Clock Display
12-hour mode PM 5:00
24-hour mode 17:00
To set to the 12-hour mode, press the
CLOCK button once in the fi rst step.
To set to the 24-hour mode, press the
CLOCK button twice in the fi rst step.
Press the TIME ADVANCE or REVERSE
button to set the current time.
• Keep the button pressed to advance or reverse
the time display quickly.
Press the SET/C button.
• The colon (:) blinks to indicate that the clock is
functioning.
operating.
2
3
1