JVC WR-MG200 Wartungshandbuch Seite 5

● Insert the O-ring after inspection
Make sure no foreign matter is adhered when placing the greased O-ring back to the
groove.
Do not pull too strongly, and make sure the O-ring is placed evenly and not twisted.
<POINT>
Insert from the four diagonal corners
and smooth out evenly.
● If you do not intend to use the marine case for a long period of time,
remove the O-ring and allow it to rest.
A Remove the O-ring.
Be sure to use the pick supplied.
B Wipe off the grease gently.
C Check for any foreign matter that might be adhered to it.
D Put the O-ring inside a clean plastic bag, and store in a way that it will not be subject to
stress.
Do not put in moth balls and other insect repellents.
Do not leave the O-ring as-is in the marine case for a long period of time.
It may deform due to heat and pressure resulting from the locked and tightened state.
Do not store in hot and humid locations.
This will cause the O-ring to deteriorate more quickly.
4
Storing the O-ring
1
2
5
3
5