First Use; Unpacking The Product; Setting Up The Product; Use - Parkside Performance Pals 50 B1 Kurzanleitung

Always unplug the mains plug from the
socket before installation, dismantling
or cleaning .
Disconnect the product from the mains
supply if it is not going to be used for
some time (e.g. holiday).
Prior to installation, verify that the
mains voltage on site corresponds with
the operating voltage required for the
product (230 V~, 50 Hz). Otherwise do
not install the product .
CAUTION! Risk of burn injuries! To
m
prevent burns, verify the product is
switched off and has cooled down for at
least 15 minutes before touching it . The
product can become very hot .
The accessible surface, especially the
heat shrink, is very hot when the lamp is
operating .
FIRE HAZARD! Fit the product
so that it is at least 1.0 metre
1 .0 m
away from the material to be
illuminated. Excessive heat can
result in a fire.
The product is only suited for use with
the built-in LED control gear.
The product continues to draw a small
amount of power even if the product is
off as long as the product is connected
to the supply mains . To switch the
product off completely, disconnect the
mains plug from the socket-outlet .
[ 7 ]
The mains plug
7 ] [
connected with a corresponding
socket-outlet with the same IP degree
in order to keep the protective degree
against dust/water .
Only for HG12247-BS: The mains
plug is suitable for indoor use only .
7 ] [
Luminaires shall not be connected after
each other .
can only be
˜ First use
˜ Unpacking the product
1 . Take the product out of the packaging
and remove all packaging materials and
plastic wrappings .
2 . Check to make sure that all listed parts
are included (see "Scope of delivery").
3. Check whether the product and all parts
are in good condition . If any damage
or defect is detected, do not use the
product, but follow the procedure
described in chapter "Warranty" .
˜ Setting up the product
(Fig. D, E)
CAUTION! Risk of injury! Note the
m
position of your hands whilst opening or
closing the tripod
pinching your fingers.
INFO:
The product may be placed on the
provided tripod
4 ] [
positioned in the desired location .
Use and operate the product on a
o
stable surface without any angle .
1 . Rotate the locking screw
clockwise to loosen the tripod
2 . Adjust the tripod
position. Rotate the locking screw
clockwise to fix the tripod in its position.
3. Fully extend the tripod
stability of the product .
˜ Use
˜ Switching the product on/off
NOTICE! Risk of property damage!
m
Do not move the mains cord
connecting the mains plug to a socket-
outlet . There is a risk that the product
will slip or tip over .
. There is a risk of
4 ] [
and then be
anti-
3 ] [
.
4 ] [
to the desired
4 ] [
3 ] [
. Check the
[ 4 ]
after
[ 7 ]
GB/CY 9