Installing The Monitor - Cartrend 90106 Gebrauchsanweisung

Intertek Project Code: 489 5025 16 000 4 00451
WIRELESS CAMERA SYSTEM FOR VEHICLES
• Use pliers (not included accessory) to fasten
the wires with the metal blade in the wire
connectors (9) ( g. 9).
• Close the wire connectors (9) to secure the
cables connection ( g. 10).
• Route the power cable (7) of the transmitter unit to the selected reverse light.
• If possible connect the wires of the power cable directly to the terminals of the reverse light,
without using the wire connectors (9).
Make sure the wires are connected rmly and the cables for the reverse light are still in good contact
with the bulb socket of the reverse light.
NOTE: If you should not be familiar with electrical installations or unsure about
one of these steps, seek help from quali ed personnel.
• Replace the bulb and covering after nishing the installation.
• Reconnect the negative cable to the vehicle battery.

INSTALLING THE MONITOR

Warning! Mount the monitor (1) with the monitor arm (2) in an area of the
windscreen, where it does not block your sight.
• Place the monitor (1) on the desired place without mounting it.
• Guide the 12V plug with cable (4) to the cigarette lighter socket or 12V power outlet.
• The cable should not interfere with the safe handling of the vehicle.
• Mount the monitor arm (2) with the suction cap on a smooth surface. Make sure to clean the
surface before applying the suction cap.
Client: SPA Tested
Project: 90106 W/Cam
Language: GB
Figure 9
Figure 10
35
Date/ :
Version/ :
Page/ :
GB
02.05.2008
04
35 (of 92 Pages)