Electric Installation - Cartrend 90106 Gebrauchsanweisung

Intertek Project Code: 489 5025 16 000 4 00451
WIRELESS CAMERA SYSTEM FOR VEHICLES
• Re t the rear number plate ( g. 5).

ELECTRIC INSTALLATION

Warning! Do not route the cable outside of the vehicle.
• For the electrical installation, rst nd the best way to arrange the cable of the camera (3).
• Some vehicles may have a hole in the vicinity of the number plate, like the number plate light.
Remove the number plate light and insert the cable of the camera (3) through the same hole.
• If there should not be a suitable hole, drill a hole of 13mm diameter.
Warning! Make sure there are no electrical cables, circuits or fuel lines behind
the place, where the hole should be drilled!
• After drilling the hole insert the camera cable through this opening. Then clip the grommet (13)
onto the cable and insert the grommet (13) into the hole.
• Mount the transmitter unit (6) in the trunk of the vehicle. Connect the camera cable to the
transmitter unit (6).
• The power cable (7) for the transmitter unit (6) has to be connected to the reverse light circuitry.
• Locate the reverse light, where the power cable (7) can be routed to in the best way.
• Turn the vehicle`s ignition to accessory position. Engage the parking brake and select the reverse
gear.
• Look at the reverse lights and locate the white reverse lights.
• Now locate the 12V + wire. To locate this wire it is necessary to remove the covering inside the
vehicle of the reverse lights.
NOTE: Refer to the vehicle's manufacturer data for speci c wiring diagrams
( g. 6).
Client: SPA Tested
Project: 90106 W/Cam
Language: GB
33
Date/ :
Version/ :
Page/ :
GB
Figure 5
02.05.2008
04
33 (of 92 Pages)