General Cleaning - clage Zip HydroTap G4 B 160 Gebrauchsanleitung

today's date where shown on the label.
7. Avoid touching the filter O-rings and filter opening as this may
cause bacterial contamination of the cartridge.
8. Moisten the O-rings with water, align the front cartridge label
to the left (as shown in the diagram for filter cartridge replace-
ment), and push the new cartridge into the filter head.
9. Turn the cartridge a quarter turn to the right until the cartridge
comes to complete stop and is locked into position, with the
front label facing forward.
10. Initiate the filter flush programme by scrolling through the menu
screen (See section C).
11. Close the door to secure the appliance.
12. Adjust the filter settings in section F - filter - litres and days used.
13. Dispose of the used filter correctly.

General cleaning

Do not use strong, corrosive, spray or abrasive cleaners. The plastic
surfaces and taps should be wiped with a slightly wet and hygienic
cloth only.
Under sink units must never be located near, or cleaned with water
jets.
Avoid using air borne pesticides near the undersink unit.
Filter Maintenance
1
2
Cleaning
Warning: If the Zip HydroTap
is switched off for a long
period of time (e.g. More
1
than a weekend), run water
through the chilled water
2
outlet for at least 5 minutes
before consumption.
35