Filter Maintenance - clage Zip HydroTap G4 B 160 Gebrauchsanleitung

LCD Screen operation - Section F
Dispense Times
The ability to change the maximum dispensing time for the hot
water has been introduced. The default settings for the maximum
dispensing times is 15 seconds. Here, the operator may change both
the hot and cold dispensing times to between 5 and 15 seconds, in
increments of 1 second. To edit the dispensing times:
1. Press the [MENU] button for main menu.
2. Press the [Setting] button.
3. Press the [Dispense Time] button.
4. Select the option to change and scroll using the up and down
arrow Keys
Water Filter
The Zip HydroTap notifies when filter replacement is due. If you
notice one of the following, you will need to change the filter.
> The Change Filter LED will flash white once a second and remain
so until reset. The filter status light is located below the levers on
the tap head assembly.
> The filter percentage will show 0% on the Home screen.
Note: Replace the filter after a non-use of more than two months,
even if the change interval has not yet been reached!
Note: Depending on local water quality conditions and usage, the
filter may require changing anywhere from 500 Ltrs to 10000 Ltrs.
You may also need to replace the filter if you notice unpleasant
odours or tastes.
Some water may drip from the filter head (socket) during replace-
ment. Keep a towel handy to dry up any drips.
To change the Filter: (See also section C)
1. Open the door of the under sink unit.
2. Relieve system pressure via the filter flush stop cock, a quick
open and close will do. Use the bucket to catch the discharge.
3. Grasp filter cartridge and rotate the cartridge a quarter turn to
the left, then gently pull down.
4. Caution: a small amount of water will drip as the cartridge is
removed.
5. Do not tilt the cartridge as water may spill from it if tilted.
6. Unpack replacement cartridge and remove sanitary cap, write

Filter Maintenance

34