Before Use - Matrix MT 220-1 Originalbetriebsanleitung

8 Grinding/Sanding sheet
9 Allen key

Before use

Check that the machine and the cable are in
perfect working order and safe to use.
Instructions for use
Comply with all the safety instructions.
Ensure that you do not cover the ventilation slits
with your hand.
IMPORTANT
Do not point the machine towards your face
when you switch it on for the first time. Any tools
which are not securely clamped may become
loose or rupture when the machine reaches high
speed.
Danger of injury!
For best results use the correct speed and suitable
accessories.
Test the correct speed using a sample piece.
Tools
Segment saw blade (3) (B1)
Materials
- Wooden materials, plasterboard, plastics and
other soft materials. Not for nails, screws, non-
ferrous metals and tiles.
Application
- Cutting in areas with difficult access and close
to edged.
- For example cutting floor strips to the correct
length. Cutting precise holes in tiles, plastics,
plasterboard and furniture.
Immersion saw blade (4) (B1)
Materials
- Wooden materials, plasterboard, plastics and
other soft materials. Not for nails, screws, non-
ferrous metals and tiles.
Application
10
- Small cutting and sawing work in constricted
areas.
- For example cutting precise holes in furniture
and for DIY applications. Cutting sections.
Grinding disc (5) (B1)
Materials
- All materials depending on grinding/sanding
sheet particle size.
Application
- Minor dry grinding/sanding work in areas with
difficult access.
- Grinding/Sanding wood, paint, glass and stone.
Assembly
Tool assembly
Fit the tool of your choice to the machine so that
mounting on the tool engages securely in the
mounting on the machine. (B2)
Secure the tool using the clamping disc (6) and
clamp screw (7).
Tighten the clamp screw (7) using the Allen key
(9).
Check that the tool is secure before you switch on
the machine.
To change the tool, undo the clamp screw (7).
Fitting a grinding/sanding sheet
Secure the grinding/sanding disc (5) with the
clamp washer (6) and clamp screw (7) using the
Allen key (9). (B3)
Place the grinding/sanding sheet (8) flush on one
side of the grinding/sanding disc, lay the grin-
ding/sanding sheet flat and press it into position
with a slight turn. (B4)
To remove the grinding/sanding disc, take hold of
it at one corner and pull it upwards.