Albrecht DB 270 Handbuch Seite 50

Deleting Channel (DEL-CH) ------ MENU 28
•
In standby mode, press MENU + 28 , the screen displays
•
Press MENU to enter, then press UP / DOWN to select the desired deleted channel,
then press MENU to confirm, the selected channel and message are deleted,
•
press EXIT return to standby.
Setting Reset ---- MENU 29
This transceiver has two resets available - VFO and ALL messages.
When you use RESET VFO, all function parameters will return to default set.
When you use RESET ALL, the transceiver with all his settings will return to the factory
default status.
1. MENU Reset (VFO):
•
In standby mode, press MENU + 29, the screen displays
•
Press MENU to enter, and press UP / DOWN to select VFO, then press MENU ,the
screen displays
.
After using the Reset function, the transceiver will auto power off and reboot again.
2. All messages Reset (ALL)
To avoid accidental reset by user, you can set the password of ALL messages Reset (ALL)
for this transceiver through PC Programming software. All messages reset will only work after
the right password is input. Please see the Programming software for the setting of password,
6 figures, while setting "000000" means canceling the password lock function.
ALL Reset (under password had been set to " 000000 ")
•
In standby, press
•
Press MENU to enter, and press UP / DOWN to select ALL, press MENU , the
screen displays
The screen displays
turn off and reboot again.
ALL Reset (under valid password as "XXXXXX" (E.g.: 123456))
•
In standby, press MENU + 29 , the screen displays
•
Press MENU to enter, and press UP / DOWN to select ALL, press MENU , the
screen will displays
•
at this time input the six figure password (e.g.: 123456), the screen displays
, the transceiver will start resetting.
After reset is finished, transceiver will automatically turns off and
CTCSS/DCS Frequency Scan ------ MENU 30
This function is to scan all CTCSS or DCS frequencies to find if the transmitting party has the
CTCSS or DCS frequencies to transmit. When CTCSS or DCS frequencies are not matched
, press MENU again to confirm, and the screen displays
MENU + 29, the screen displays
, then press MENU again to confirm.
. When the reset is finished, the transceiver will automatically
,
restart.