Before Putting The Machine Into Operation - EINHELL RT-HP 1545 Originalbetriebsanleitung

Anleitung_RT_HP_1545_SPK1:_
GB
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60335-1.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60335-1.
Vibration emission value a ≤ 2,5 m/s
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
16
16.06.2010 9:38 Uhr Seite 16
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
76 dB(A)
3 dB 6. Before putting the machine into
95 dB(A)
operation
3 dB
6.1 Correctly using the device
b The high-pressure cleaner must be set on a
level, stable surface..
It is recommended that you maintain the correct
b
operating position every time you use the
machine by placing one hand on the pistol and
the other on the lance.
2
b Never direct the water jet toward electrical lines
or the machine itself.
b It is normal for the pump to leak a little; this is
necessary to avoid damage to the pump when it
is at a standstill.
b Never use the equipment in potentially explosive
areas under any circumstances!
b The operating temperature must be between +5
and + 40°C.
b Do not cover or modify the lance or the spray
nozzles in any way.
b The high-pressure cleaner is designed to be
used with cold or lukewarm water (max. 40°C);
higher temperatures can damage the pump.
b Do not use water that is dirty, gritty or contains
any chemical products, as these could impair
operation and shorten the life of the equipment.
Caution: Risk of explosion
Do not spray flammable liquids.
Warning
Water that has passed through the non-return valve is
not drinkable.
Important
If cleaning agent gets into contact with your skin or
into your eye, rinse immediately with lots of clean
water. Then consult a doctor or follow the steps
described on the safety data sheet or provided by the
manufacturer of the cleaning agent.