Initial Use; Charging The Device; Attaching The Brush; Use - Beurer FC 96 Gebrauchsanweisung

7.

Initial use

7.1 Charging the device

Charge the device for at least 4 hours before initial operation. To do this, proceed as follows:
1. Insert the mains cable into the charger.
2. Insert the mains adapter into the socket.
3. Insert the facial brush into the charger from above. The facial brush display lights up whilst charging is in progress.
The battery symbol

7.2 Attaching the brush

1. The attachment you wish to use should be fixed from above onto the mounting fixture of the device.
2. To remove the brush attachment after use, pull it up and off.
8.

use

1. Moisten the attached brush attachment with water. Never use the device with a dry brush attachment as this can ir-
ritate the skin.
2. Apply the cleansing gel to your facial skin.
3. To switch on the device, press and hold the ON/OFF/speed button for 1 second. The brush attachment will begin to
rotate.
4. The device has four speed settings. To switch between the individual speed settings, briefly press the ON/OFF/speed
button. The selected speed setting is displayed via the corresponding circles in the display that are lit up.
5. Using the rotation button, select your desired rotation level. The device has circular rotation for gentle facial cleansing
and oscillating rotation for thorough facial cleansing.
6. Now apply the device gently to your face and cleanse your facial skin using even movements to remove residue, dirt
and dead skin cells.
Note
To ensure comfortable treatment, do not apply the rotating brush attachment too firmly to the skin. Treat each section of
skin for a maximum of 20 seconds only.
The brush features a 1-minute timer and stops every 20 seconds for 1 second to indicate that you should switch to clean-
sing a different area. The facial brush switches itself off automatically after 3x 20 seconds. The recommended application
period per use is 1 minute.
If the facial brush displays the following symbol
is the only way to continue to ensure optimum cleaning performance. You can obtain a new brush attachment in shops
or from the relevant service address (as specified in the service address list).
After you have changed the brush attachment, hold down the ON/OFF/speed button and the rotation button at the same
time for at least 2 seconds. The symbol
7. Switch off the device after use. To switch off the device, press and hold the ON/OFF/speed button for 1 second.
8. Cleanse your face thoroughly with water to remove any residue from your skin.
9. Pat your skin dry with a towel and then apply a moisturising cream using even, circular movements.
in the display shows the current charge status.
illuminates continuously again.
in the display, we recommend changing the brush attachment. This
11